Additional information
| Weight | .6875 lbs |
|---|---|
| Dimensions | 6 × 5 × 0.3 in |
6654 Lafayette Rd
Chickamauga, GA 30707
M-Fri 8 AM – 4 PM
Store 423-762-5858
Fax 706-375-6137
Email QTMParts@yahoo.com
Spindle Hardware Kit
$13.00
This a new very high quality set of spindle hardware. This is for the front axle of the MB, GPW, CJ2A, CJ3A, Cj3B, M38, M38A1, and early CJ5. These will also fit the Dana 27 full floating rear axle on the WWII jeeps. These are almost always totally worn out or torn up by Bubba using a chisel and hammer to remove them. These are what hold not only the outer bearings in place but the whole hub on. These are not cheep China or India made junk. These are made in Canada. This is enough for two hub assemblies. NOTE: We carry the correct tool to install/Remove these.
